📞 Call for Free Quote — (407) 922-9857
Pool Deck CleaningClermont, FL
Algae and mildew take hold in a pool deck surface, and that growth makes a wet deck slick and leaves concrete, pavers or travertine looking dirty. We pre-treat the growth, then match the method to the surface — durable concrete can take higher pressure, pavers get controlled pressure with care for the joints and joint sand, and travertine gets a cleaning solution, dwell time and a controlled low-pressure rinse — to leave the deck cleaner, more even, and less slippery.
Why Clean Your Pool Deck in Clermont
Lifts the Slick Algae
Wet algae is why a pool deck gets slick. Lifting it out of the surface is what leaves the deck less slippery underfoot.
Slows the Regrowth
Pre-treatment kills the algae and mildew itself, not just the surface film, so the result lasts longer than a water-only rinse.
Right Pressure per Surface
Higher pressure where the slab allows it, controlled pressure on pavers with attention to the joints and joint sand, and on travertine and coatings a cleaning solution given dwell time, then a controlled low-pressure rinse.
Bright, Even Finish
The deck dries to an even, light finish instead of the patchy grey-green it had before.
Get a Free Quote
Response within 1–3 business hours — no pressure, no obligation.
✓ No spam. We only use your info to reach you about your quote.
Why Clermont Homeowners & Property Managers Trust Us With Their Pool Deck
A dirty pool deck isn’t just an eyesore — it’s a slip hazard. The black and green film that builds up on a pool deck here is algae, and algae holds water and turns slick the instant the surface gets wet. That’s the exact spot where people walk barefoot, usually in a hurry, right at the edge of the water. Lifting that growth out of the surface is the whole point, and it is what the job is built around.
Water pressure alone lifts the surface film and leaves the growth down in the pores, which is why a water-only cleaning greens up again so fast. We pre-treat first. A surface-appropriate cleaning solution goes across the whole slab to kill the algae, mold and mildew itself, with the strength and dwell time set by the material and how heavy the growth is — and extra attention on the shaded, slow-drying areas where it builds up worst. Only once that has done its work do we clean, matching the pressure to the surface. Treating the growth instead of rinsing it off is what makes the finish last.
Then there’s the look. Once the algae is lifted, what is left is the staining that reads as neglected: leaf tannins under the screen cage, rust from patio furniture, and the mineral deposits a water-only rinse leaves behind. Some rust, mineral and organic stains may need additional spot treatment depending on the surface and how far they have set in. The result we are after is a deck that looks clean and even, and is less slippery underfoot than it was.
We’re owner-operated out of Kissimmee and we serve Clermont. We know what a Central Florida pool deck deals with: humidity, summer rain, pollen, and sunscreen ground in around the waterline. We match the method to what your surface can take.
What Makes Us Different:
- Algae and mildew lifted out of the surface, so the deck dries less slippery
- Right pressure per surface — higher where durable concrete suits it, controlled pressure on pavers and care around the joints and joint sand, and on coatings a dwell-time treatment before a controlled low-pressure rinse
- We work inside the screen cage and direct runoff away from the track and the pool
- Rust, calcium and leaf-tannin staining may need additional spot treatment, depending on surface and severity
- Before-and-after photos on request, useful for property managers and community associations
Cleaning the deck and the enclosure together? See our pool cage cleaning in Clermont — we soft wash the screens and frame the same visit. Want the pavers protected afterward? We also handle paver sealing in Clermont, so one crew cleans, then comes back to seal. Prefer to see the full range of what we clean? Start with our Clermont pressure washing hub or browse our soft washing services.
Have Pavers? Ask About Sanding & Sealing
Sealing is a separate service, not part of a standard pool deck cleaning. If you have a paver pool deck, we can come back once the surface is fully dry — typically the following day or as weather conditions allow — to re-sand the joints as needed and apply a professional paver sealer. That helps stabilize the joint sand, protect the surface, preserve its appearance depending on the sealer selected, and make future maintenance easier. One crew, from cleaning through sealing.
Every pool deck cleaning is backed by our 100% satisfaction guarantee. We’ll review the completed work with you, and if something we cleaned was missed or isn’t up to our standard, we’ll make it right.
Property Assessment & Firm Quote
In most cases, we can price your pool deck remotely without scheduling an onsite estimate. We’ll ask a few questions about the surface, size, condition, and areas you want cleaned, then provide a firm quote — usually within 1–3 business hours.
If we can’t accurately assess the property remotely, we’ll arrange an onsite visit. Once your quote is approved, your price won’t change unless the scope of work changes.
Choose Your Service Date
Choose a service date that works best for you. We’ll confirm your appointment in advance and send you a text when our crew is on the way.
Same-week appointments may be available depending on our schedule.
Property & Landscaping Protection
Before applying any cleaning solution, we thoroughly pre-wet nearby plants, shrubs, grass, and surrounding areas. Throughout the service, we continue rinsing and monitoring landscaping that may be exposed to overspray or runoff.
We can move a small amount of lightweight furniture when needed. If the deck has a large amount of furniture or heavy items, we can clean around them or add a small fee for furniture moving. Delicate items and surrounding surfaces are protected or avoided as needed.
Pre-Treatment Application
We apply a surface-appropriate cleaning solution across the pool deck to treat algae, mold, mildew, and other organic buildup — rather than relying on water pressure alone.
The strength of the treatment and dwell time are adjusted based on the surface material and its condition, with additional attention given to shaded and slower-drying areas where organic growth tends to be heavier.
This helps loosen the buildup before cleaning and helps the surface stay cleaner longer than a basic water-only cleaning.
Surface-Appropriate Cleaning
Every pool deck is cleaned according to the material — not with the same pressure across every surface.
On durable concrete, we can use a commercial rotary surface cleaner to produce an even, consistent finish. Pavers are cleaned using controlled pressure to minimize unnecessary disturbance of the joint sand.
For travertine, painted pool decks, coatings, or other more delicate surfaces, we rely more heavily on the proper cleaning solution, dwell time, and low-pressure rinsing instead of forcing high pressure onto the surface.
The goal is simple: use the cleaning method the surface actually calls for.
Edge Detailing & Final Rinse
Once the main surface has been cleaned, we detail the areas larger equipment can’t properly reach — including borders, coping, steps, corners, and edges around the pool and screen-track areas where applicable.
The entire deck is then thoroughly rinsed, along with surrounding areas and landscaping.
Post-Treatment for Longer-Lasting Results
When appropriate for the surface and its condition, we apply a final treatment to address remaining organic staining and help slow the return of algae and mildew.
This finishing step helps give the deck a cleaner, more even appearance and helps it stay cleaner longer between professional cleanings.
Pressure Washing vs. Soft Washing
A pool deck is a hard surface, so pressure is the right tool for the slab. But the surfaces around it — including the screen cage overhead — are delicate. Here’s how the two methods split the work on a Clermont pool area.
Pressure Washing
A commercial rotary surface cleaner, run at the pressure each surface takes — an even way to work ground-in algae and buildup out of a pool deck.
- Broom-finish and smooth concrete decks
- Concrete and brick paver decks
- Pool deck coping, steps and walkways
What We Soft Wash Instead
The slab takes pressure; the surfaces around and above it don’t. On these we switch to a low-pressure soft wash instead, which avoids the damage high pressure causes:
- The pool cage / screen enclosure — high pressure tears mesh out of the frame
- Kool Deck and other cool-deck coatings that strip under a wand
- Travertine and natural stone — treated, given dwell time, then rinsed at controlled low pressure
- Screened lanai ceilings, roof edges and gutters above the deck
- Wood and vinyl fencing bordering the pool area
- House siding and stucco backing onto the deck
Pool Deck Surfaces We Clean in Clermont
There’s no single “right pressure” for a pool deck — the correct method depends entirely on the surface. Here’s the method we use on each one.
Broom-Finish & Smooth Concrete — High Pressure
Durable and forgiving. A commercial rotary surface cleaner at higher pressure gives an even, streak-free finish across the whole slab.
Concrete & Brick Pavers — Controlled Pressure
Cleaned with controlled pressure, with attention to the joints and the sand between them. Cleaning a paver deck moves some joint sand, so joints can be re-sanded afterward, and sealing is available as a separate service.
Travertine — Treated, Then Low-Pressure Rinse
Natural stone etches under high pressure. We apply a cleaning solution and give it the dwell time the stone and its condition call for, then rinse at low, controlled pressure.
Kool Deck / Cool-Deck Coatings — Low Pressure
Textured cool-deck coatings strip under high pressure. We soft wash instead — a cleaning solution, the dwell time the coating needs, then a controlled low-pressure rinse, adjusting the approach to the coating and its condition.
Stamped / Decorative Concrete — Low Pressure
Painted and coated decorative finishes need the gentler route: a cleaning solution, dwell time, then a controlled low-pressure rinse matched to the finish and its condition.
Screened Lanai Decks — Inside the Cage
Where the deck sits inside a screen enclosure, we work inside the cage, direct runoff away from the track, and clean up to the frame.
What Putting Off a Pool Deck Cleaning Costs You, Not Just an Eyesore
Putting it off isn’t only a cosmetic decision. On a pool deck it is also a traction problem and a staining problem, and both get harder to deal with the longer you wait.
Wet algae on a deck is slick, and a pool deck is where people walk barefoot. Removing the growth is what reduces that.
A black-streaked deck reads as dirty from across the lanai, and it is usually the first part of the pool area a guest notices.
Rust, calcium and organic staining can work into the surface over time. The longer it sits, the more likely it needs additional spot treatment, and some staining may not come out completely.
Results That Speak For Themselves
What Our Customers Say About AB Superior Wash
“I can’t say enough about Alejandro’s professionalism. He answered all my questions, and I had a lot of them. He scheduled the cleaning when it was convenient for me, showed up on time, and completed the driveway cleaning within a reasonable time. I highly recommend this company!”
“Excellent service! They knocked on my door offering a driveway cleaning. They showed me some of their work and I was very impressed, so decided to give them a chance. It turned out even better than I expected! Very professional and affordable pricing — I definitely recommend AB and will use them again.”
“Very professional and reasonably priced! Will definitely recommend!”
Areas We Clean Pool Decks In & Around Clermont
Screened lanai decks and open pool surrounds, concrete, pavers and travertine alike — same surface-matched method, from 34711 out to 34714.
34711
34711
34711
34711
34711
34711
34714
34711
Pool Deck Cleaning Clermont FAQ
What homeowners and property managers here ask us before we clean their deck.
How much does pool deck cleaning cost in Clermont?
Do you clean pool decks in gated communities?
Is my pool deck slippery because of algae, and will cleaning fix it?
Will pressure washing damage my pavers or travertine deck?
How often should I clean a pool deck in Clermont?
Do you also seal paver pool decks after cleaning?
Why Pool Decks Get Slick in Clermont
Most people book a pool deck cleaning because the deck looks dingy. That’s fair — but the more important reason is underfoot. A pool deck is a surface where algae and mildew take hold readily. Wet biological growth is slick, and a pool deck is the one place where everyone is barefoot and often moving fast. Clearing that growth is what makes the deck less slippery underfoot, which is why we treat algae removal as the core of the job — not an afterthought.
Pool decks cover a wide range of surfaces, and that is what decides the job. Screened lanai decks, open paver surrounds, poured concrete, travertine and coated finishes all behave differently under pressure and under chemistry. What does not change is the sequence: identify the surface, treat the growth, then match the pressure to the material.
The fastest way to ruin a pool deck, though, is to clean it like a driveway. Durable broom-finish concrete can take a rotary surface cleaner at real pressure. But travertine, Kool Deck and other cool-deck coatings, and stamped or painted concrete will etch, strip, or blotch under that same wand — so we identify the surface first, then treat those finishes with a cleaning solution left to dwell, followed by a controlled low-pressure rinse suited to the material and its condition. We also protect the deck’s neighbors: the pool water, your landscaping, and the screen enclosure track. We control runoff to limit how much cleaning solution reaches the pool or the storm drains. Rust and calcium staining may need additional spot treatment, depending on the surface and how severe it is, because pressure alone is not a stain remover.
We clean pool decks throughout Clermont — screened lanai decks and open pool surrounds alike. If you want the screen enclosure cleaned in the same visit, we soft wash it too; see our pool cage cleaning page, and for everything we cover across the region, see our full Central Florida service area.
AB Superior Wash371 Bald Cypress Dr, Kissimmee, FL 34744
Phone: (407) 922-9857
Hours: Monday–Sunday, 7:30 AM – 8:00 PM
Written by Alejandro Garcia — Owner, AB Superior Wash · (407) 922-9857 · Open every day, 7:30 AM–8:00 PM
Last updated: July 2026
Ready For a Cleaner Pool Deck?
Algae and buildup lifted, the deck cleaner and more even, and less slippery than it was — concrete, pavers or travertine, inside the cage or out.
